It is made from C1215 steel and has a flat head (countersunk) 3/8-16 bolt that inserts from below. In the middle is the bolt I made for my KDK Series 0 toolpost. ![]() It is partially threaded so the bolt cannot go through the nut and contact the bottom of the T-slot. It appears to be stainless, and hase a 7/16 - 14 thread. ![]() On the left is the T-nut I got with the KDK Series 100 toolpost, likely made by the shop that previously owned the HLV-H. Perhaps it a description problem with people using different terms to describe “hold down bolt”. I tried advanced search and literally got nothing. Just want to know if I’m doing things the right way and if anyone has any suggestions. I haven’t had any problems with the bolts I’ve made but I wanted to tap into the vast knowledge base here. This new one is going to be for a Multifix E toolpost. ![]() I’m about to make my third toolpost hold-down bolt for my Hardinge HLV-H in less than a year.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |